PCS Gladiator (Movie) Maximus 1/3 statue

[Gipetto0812]

Pretty sure the BigChief Studios one was licensed
- https://www.collectorfreaks.com/thr...-collector-figure.173752/page-8#post-10528121
- https://www.sideshow.com/collectibles/gladiator-the-spaniard-big-chief-studios-902979
Well, until they went under.

Yup, I remember that, but since it was cancelled while it was still in preorder phase due to too low PO numbers/lack of interest therefore never released, I don’t count that. I guess technically this statue hasn’t been released either but it may have a better chance than BCS did.

 

[Gipetto0812]

Exclusive only available through PCS:
EX items are helmeted headsculpt and shield arm
https://collectpcs.com/gladiator-maximus-platinum-ex/

Regular can be purchased from Sideshow:
https://www.sideshow.com/collectibles/gladiator-maximus-pcs-913603

 

[Ombudsman]

During this “early bird” period, it appears that the version at PCS (which has the switch-outs) is currently cheaper than the simple version (without switch-outs) at Sideshow from what I see.
I just put my order in-wanted a Maximus for a long time. 1/3 will make this a center piece in my small collection

 

[JacktheRipper]

Well, look at that! It's got real sand.

 

[nexus]

Not bad. I think the face is kind of wide and the body looks a little thicker than Crowe’s. I still have a cool 1:4 custom Maximus from years ago that I still need to sell.

 

[K1LLJOY]

This looks like one of PCS's best efforts, I really like it. I hope PCS makes one in 1/6 or 1/4th.

 

[Shoo]

SDCC:

 

[sabin23]

Well, look at that! It's got real sand.

I don't like sand. It's coarse and rough and irritating and it gets everywhere.

 

[Shoo]

 

[sabin23]

PO’d at PCS this week.

 

[marker2037]

Looks really good for those who are looking for this type of centerpiece. I'd consider this if it was 1/4 scale, but at 1/3 it's too big for my display and not an important enough line