Hi all,
Just ordered the PAX unit in the image below. I want to put LEDs into it and was wondering if anyone had advice.
I know I want to do daylight white or the ones that are fully white with no yellow in them.
Unsure about strip lights vs bar lights, and what would be the most sturdy and easiest to put in. There are tons of options, not sure what to get. I want something high enough quality to last a long time and be dimmable if possible.
Should I drill a hole in the middle of the unit and run strips through each layer and then down, or do each shelf itself and run it out the back etc??
Each shelf is 29" wide. Total width about 60" and around 80" tall.
Would I need a better AC unit to power all of them at once? I would like to make it powered on by a switch or my phone if possible.
If anyone has any advice that would be amazing. I'm excited but nervous because I want it to look good lol
Just ordered the PAX unit in the image below. I want to put LEDs into it and was wondering if anyone had advice.
I know I want to do daylight white or the ones that are fully white with no yellow in them.
Unsure about strip lights vs bar lights, and what would be the most sturdy and easiest to put in. There are tons of options, not sure what to get. I want something high enough quality to last a long time and be dimmable if possible.
Should I drill a hole in the middle of the unit and run strips through each layer and then down, or do each shelf itself and run it out the back etc??
Each shelf is 29" wide. Total width about 60" and around 80" tall.
Would I need a better AC unit to power all of them at once? I would like to make it powered on by a switch or my phone if possible.
If anyone has any advice that would be amazing. I'm excited but nervous because I want it to look good lol
