If you enjoy 3D printing, go for it. I personally only 3D print as a means to the end. I find it difficult, inconsistent and frustrating but I powered through several failed prints and reprints because I really wanted that Kenner life size!
Just a tick over 18 inches deep. Funny enough, I think I used the measurements on Grievous when designing the built in depth
Thankyou. Yer I can see why you would use him for the depth. I'm gathering the height for each shelf is around 27/28 inches?Just a tick over 18 inches deep. Funny enough, I think I used the measurements on Grievous when designing the built in depth
Yes, the top shelf is closer to 29 inches so about an inch taller than the middle and lower, which I would love to tell you was intentional, but I just messed up my original calculations! It honestly worked out pretty well as there are a couple of statues that would be very tight without that extra inch.
Tell the wife I love the additions !! F*ing Fett-tastic !!!
I told her...she did not care for your opinion anymore than mine
Not that it'll help in the slightest, but you can tell her she is outvoted and officially in the minority....I told her...she did not care for your opinion anymore than mine
I'm 53 and bald...I might just dress up and roam around the basement
Yes Brie, it is...Temuera Morrrison is that you?
I liked how you use those niches to display your Star Wars statues rather than getting somekind of furniture.
