Darth Dennis? Man Cave

Collector Freaks Forum

Help Support Collector Freaks Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
It looks great. I've been thinking of doing a 1:2 scale one, but not sure.
If you enjoy 3D printing, go for it. I personally only 3D print as a means to the end. I find it difficult, inconsistent and frustrating but I powered through several failed prints and reprints because I really wanted that Kenner life size!
 
Can I ask how deep have you done the shelving for the statues please? Every statue seems to fit on the depth perfect even general grievous.
 
Just a tick over 18 inches deep. Funny enough, I think I used the measurements on Grievous when designing the built in depth :)
Thankyou. Yer I can see why you would use him for the depth. I'm gathering the height for each shelf is around 27/28 inches?
 
Last edited:
Thankyou. Yer I can see why you would use him for the depth. I'm gathering the height for each shelf is around 27/28 inches?
Yes, the top shelf is closer to 29 inches so about an inch taller than the middle and lower, which I would love to tell you was intentional, but I just messed up my original calculations! It honestly worked out pretty well as there are a couple of statues that would be very tight without that extra inch.
 
Being a builder I did think was the middle and lower slighly lower but never the less it looks awesome and given me some great ideas when I move soon and build a new display room. Thankyou for your help.
 
I’ve added two more life size Fetts to the party and I think I am legit done doing them for myself. I’m opening up for commissions so hopefully I can continue the hobby and maybe make a buck or two to help offset the collecting habit. Here’s my post sarlaac Fett, Holiday Special Fett and an updated room view

79CE0150-AEF4-47CC-A788-AB7EBE438254.jpeg
859F3519-504F-4D11-8DB4-8BD2A463087B.jpeg
77D56271-F482-4CDC-BB4C-F983B683CA9B.jpeg
 
Nice collection. :) I liked how you use those niches to display your Star Wars statues rather than getting somekind of furniture.
 
Last edited:
Someone asked about my life size Fetts and I realized I hadn't updated this thread for a while. I've since built two more life size (Kenner and Arena) bringing my total to nine! I also have the life size action figure I 3D printed. Here's a look at all of them plus a view from my desk to give you an idea how the heck I found space for this many. My wife swore I ran out of space at three!

Desk View.jpg
ESB Fett.jpg
ROTJ Fett.jpg
Fresh Fett.jpg
Post Sarlaac Fett.jpg
Supertrooper Fett.jpg
PP2 Fett.jpg
Holiday Special Fett.jpg
Arena Fett.jpg
Kenner Fett.jpg
 
Stunned. I've looked at A LOT of PP2 helmets and I've never seen one done that well. The methods dreamwave used, by nature, I think are not truly replicable. Those really poor pics floating around of the prop helmet that finally turned up, up close has this consistent (despite all the mist coats) mostly gray-blue-but-a-little-green that is gorgeous, and it looks proper nailed on yours. The differing finishes between each piece of torso armor is chef's kiss too. That super matte (with a light grime filter perhaps) stomach plate is so good. Just gobsmacked by the lot of them. I could go on for a week picking these apart with praise. 😄
 
Back
Top