Hot Toys - TMS051/2 - Mandalorian and Grogu (Season 2)

Collector Freaks Forum

Help Support Collector Freaks Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Cape is the same. It's accurate in terms of being grey the definitely think some lighting makes it look a bit chocolate brown though It's definitely grey on screen. I however removed the wires from it. Though I also bought a spare with the wires if I ever wanted to put that back on him.
How do you remove the wires without ruining the cape I’ve always wondered how but never found out how?
 
How do you remove the wires without ruining the cape I’ve always wondered how but never found out how?
Hot toys is notorious for using cheap glue on their figures that it falls off sometimes. I'd say if anything you can heat it lightly with a blow dryer and peel the excess fabric off then remove the wire from the bottom and middle of the cape, For the inside at the start of the wire at the collar, cut a slight hole where it's not noticeable using an exacto knife enough so you can access the wire, and with wire cutters (small ones) clip the wire, and pull it out using thin plyers.
 
Hot toys is notorious for using cheap glue on their figures that it falls off sometimes. I'd say if anything you can heat it lightly with a blow dryer and peel the excess fabric off then remove the wire from the bottom and middle of the cape, For the inside at the start of the wire at the collar, cut a slight hole where it's not noticeable using an exacto knife enough so you can access the wire, and with wire cutters (small ones) clip the wire, and pull i

Hot toys is notorious for using cheap glue on their figures that it falls off sometimes. I'd say if anything you can heat it lightly with a blow dryer and peel the excess fabric off then remove the wire from the bottom and middle of the cape, For the inside at the start of the wire at the collar, cut a slight hole where it's not noticeable using an exacto knife enough so you can access the wire, and with wire cutters (small ones) clip the wire, and pull it out using thin plyers.
Thanks dude I’ll definitely do that on it because sometimes them capes can get annoying I appreciate it though thank you
 
Back
Top