Prime 1 Arkham City Poison Ivy 1/3 Scale

[67L88Stingray]

I like the pose and smaller base of this one, but not the outfit...

Leg position is very awkward. Would have been nice to see some swap out arm options as well.

 

[dan350zr]

I think her outfit looks great especially compared to SS last Ivy PF which came out horrible looking IMO... I do think the only portrait I would use is the EX as it's the only one that shows some personality, the other other two portraits are rather lifeless... I like this one so much I went ahead and order Arham Harley and Catwoman to display with her... luckily Prime 1 still had a few in stock...

 

[darkeyes]

Just got notice Prime 1 cancelled my order, so I guess this is not going to be produced.

 

[67L88Stingray]

No shock there. I just wonder if they end up redoing her. I would still like to get this version, but they needed to do a better job. After their home run Hush version, this was a huge letdown.

 

[darkeyes]

I received the statue today, it looks very nice although getting the feet into the base was a bit tricky. Unfortunately, it seems to have a broken part. There is this vine that wraps around the large vine #3 part, but it was broken in half. Even more strange the part does not seem to have a natural break, there is this grove cut into it almost like it was purposefully broken. I can see where the vine is supposed to connect to the base, so I assume it is supposed to be there. Anyway, I put a request into Sideshow, so we will see what happens.

 

[67L88Stingray]

Probably an air pocket in the mold, then was a weak point and didn't take much to break. Hopefully they have a replacement part.

 

[darkeyes]

Probably an air pocket in the mold, then was a weak point and didn't take much to break. Hopefully they have a replacement part.

Just got a reply from SS that they are sending a new part #3, so that's good news! I was kind of worried because that is the main large vine that runs behind the figure.