Hot Toys - DX13 - T2: T-800 (Battle-Damaged Version) 1/6-scale Collectible Figure

[DoggieDoc]

Hey everyone, accepting payment for the MM1 gas launcher in 1:10, 1:6, and 1:4 scale!

https://www.sideshowcollectors.com/...scale-master-print-complete-casting-soon.html

 

[EndoSickness]

With my new daylight soaked set up, this guy was desperate for a new shot:

 

[a-dev]

Very nice. Good angle on him.

 

[P.]

the message is too short

 

[FlyAndFight]

Looking forward to receiving the launcher and control box. Looking great so far.

 

[SilentSurfer]

I've got my second DX13 set up as semi-damaged and waiting on that launcher.

 

[SilentSurfer]

Anybody know any good replacement options for the DX13 pants belt? I got a second, clothed body and wanted to switch to my spare MMS117 pants to hide the damaged knee, but the DX13 belt pretty much disintegrated like my MMS117 belt did.

I expect this is common, so I figure somebody has managed a fix or replacement. Glue only makes it worse.

 

[a-dev]

I had the same experience with a DX10 belt recently so I could do with the same advice. I probably need to replace a few belts in fact such was the frequency that I swapped bodies and pants on my figures.

 

[SilentSurfer]

I hate Hot Toys for all their rotting materials.

 

[a-dev]

Well to be fair maybe it's hard to make a 1:6 scale trouser belt that won't fall apart with use sooner or later - unless you make it plastic. Although if it happens when it was something you only just bought that was listed as 'new' it's harder to take.

 

[SilentSurfer]

If it were real leather, and not just some crap laminated onto cloth...

 

[zxTASKMASTERxz]

New 1/4 statue, what do u guys think about the sculpt?

 

[snoop101]

The same thing is happening with my dx13 belt, it's "peeling" so to speak.

 

[Mr. EcKo]

I'm going to have to check all mine now

 

[Mr. EcKo]

Lots to check

 

[Darth Fok]

Mine are displayed in a cabinet and out of the sun. I'm afraid to check the belts now in fear of them falling apart

 

[Dollmanron]

Mine had some kind of film on it.

 

[SP1772]

I'm thinking tomorrow I'm going to finally try to finish my DX10 endo arm. So I purchased a spare DX13 battle damaged arm and a spare MMS117 endo arm. I cut the endo arm out of the flesh, now I just need to cut off the BD remains. I'm not sure of the best way of doing this without damaging the DX13 flesh and leaving myself a nice surface to glue them together. Anybody have any suggestions?

 

[Mr. EcKo]

I'd say warm it up in either hot water or a hair dryer. What are you trying to do?

 

[SP1772]

I don't have a MMS117. But I would like the option to pose the dx10 with the exposed endo arm.