Thanks Kal-El!
That is far and away the best Bale Batman of any scale I have seen. Is it possible for you to list what you did?
Thanks Dylan!
I unstitched and removed the legs of the suit at the waist and the arms at the shoulder seams.
The fatsuit underneath is also cut off from the waist down and removed.
Only kept the fatsuit padding under the upper body.
custom made the new legs and arms out of black mesh material that best matched
the upper body of the dx12.
using the same steps outlined by Thrustmaster on his "medix 2.0" from a few years back,
I cut the armor parts for the legs and pasted them on the new black mesh leggings.
Half of the armor parts (the ones in front) are from the medicom figure.
The ones on the outer sides of the leg are mostly dx12.
Codpiece and knee armor are from dx02. The two armor pieces on each side of codpiece I made myself
out of spare dx12 pieces.
Boots are from medicom's begins figure. I needed to heat them in boiling water and stretch them out a bit
so they'd fit this figure.
gauntlets are cut from the medicom figure. fists are medicom too.
the new straps that go around his biceps are cut from medicom figure.
I kept the biceps bracer armor from dx12 and glued that over those straps.
belt is from armory set. It needed to lengthened to fit around the new body,
so I added a link near the back.
The shoulder armor plate is separated into two.
cape is Tony Mei's.
Also tried making the shoulder armor more rounded, like in the movie.
I heated them in the microwave for a minute, then quickly
pressed my thumb on the inside to get it rounder before it cooled.
I never take enough pics while working, but here's a few I took during.