SixthScaleEdward
Super Freak
Am I the only one excited for this?
Finally owning a piece from the movie that dragged me into Star Wars.
GINO said:
Screen-Used Darth Maul saber 101
1. There were no metal body versions of this saber made for the film. Some were cast resin bodies with separate metal ends, and some were completely resin including the ends.
2. All the buttons on these sabers were part of the resin casting and painted. No version of Maul's saber used actual separate buttons.
3. Every screen-used version we came across in our research did not have actual emitter holes. There is only one shot in the entire film where you can see a saber emitter with a hole in it.
4. There were several different types of Darth Maul sabers used in Ep. 1. (not including the ones sliced in half by Obi-Wan)
The ones most commonly known are the hero version (for close-up shots), and the standard dueling versions (for most of the combat scenes).
Another is the HERO dueling version, which is what the EFX replica is based on and there were only a few of these made for the film.
Hero version
- Created by casting a resin saber body over a threaded rod, with metal ends added.
- Includes a covertec clip and retains all of the silver and red button detailing.
- Threaded rod is sliced off flush with the emitter ends.
- Emitter ends are flat and do not have recessed centers.
Standard Dueling version
- Created by casting a resin saber body over a threaded rod, with metal ends added.
- No covertec clip added, and all the raised button detailing has been sanded off and replaced with painted dots (so that Ray Park could twirl the saber without the raised buttons getting caught on his gloves).
- The threaded rod extends well beyond the saber body so that the colored dueling blades have something to be attached to.
- Emitter ends have recessed centers.
Hero Dueling version
- Exactly the same as the standard dueling version, except it retains all the raised button detailing (this is a hybrid of the hero and standard dueling versions).
The EFX Legend Edition version is going to emulate the Hero version in every way, except that the emitter ends will be representative of what is seen on screen vs. the actual film prop (which does not have a recessed center or an emitter hole).
In the pictures of the EFX prototype shown above, the emitter ends are just temporary stand-ins and will be replaced with metal ends that have recessed centers and an emitter hole as seen on screen.
Last edited:
I'm liking the weathering so far.
glad I'm not the only one excited. 
