Is the head plug too tight on the neck's ball joint, or is it bottoming out? Apologies in advance if I'm stating the obvious here: If it's the former, you can open up the I.D. of the plug by boring it out by hand* with a slightly larger drill bit; if it's the latter, you can extend the hole a bit deeper into the head using the same technique (but use a drill bit the same size as the plug I.D.).
I couldn't tell you - I inspected the MBJ sculpt, but I never bothered to put it on the body.
* - Just to be clear: When I say by hand, I mean hold the bit in your fingers - no power tools (i.e., electric drills) allowed!!
Thanks for the advice Buffinator, but I'm not handy enough for a job like that...nor do I have the balls to attempt any non-reversible modifications on my precious $200+ toys!
It's pretty much the equivalent of a kid sharpening a No. 2 pencil with one of those old mini-sharpeners - just put the head on the drill and twist. Just make sure to stop before the drill comes out the top of the head! And all of these heads use the same cylindrical plug inside, so if you were to accidentally make it too large/loose, just grab a needle-nose pliers and pull another one out of a head you're not using.
Not handy enough???
Haha, see the latter part of my previous statement...my balls be lacking!
Any interest in selling the sculpt?
...been working on the King/Reverend version of Killmonger. I?ve searched far and wide for a way to make the necklace. So far a paper cut out will do lol.
I?m so glad I went the extra mile and got the HT headsculpt. I previously had the angry Nutpiz sculpt it was nice, however it?s just not quite at the HT quality yet. I?ll end up just painting the scars with thick acrylic. Somehow I?ll find a better neckpiece? any suggestions would be great
Sent from my iPhone using Tapatalk
