Hot Toys - QS002 - The Terminator: 1/4th scale Endoskeleton Collectible Figure

Collector Freaks Forum

Help Support Collector Freaks Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Wow.. is that the new 1/4 HT Endo? That looks.. totally 100% accurate, just like the one in the movie....

Did Stan Winston build that from scratch.. no one can tell the difference !!

Or is that an actual prop used in the film? I almost DARE anyone to point out any inaccuracies... cause their arent any.

wait for it.... wait for it.... :impatient:

In all fairness, it's a vast-improvement over the prototype...
 
Wow that head is not only too small, it's too thin. Did they forget it was supposed to be arnolds skeleton? Hope this one turns out better than these pictures or i will quickly sell mine.
 
I wish there was a confirmed release date already, if it's April I will bump up my Flex pay earlier. My last payment is April 25.
 
521587_10151343782052344_992664422_n.jpg
 
Darn i hope there will be some of these in july, i didn't think this would really come out
in april so i used the money to buy the enterbay batman and obi-wan.
Now with my dx11 around the corner and scar in may, july would be when i can get one.
 
Electroplated endoskeleton? Like the electroplated CA shield with flaking issues? Hope not.
 
Electroplated endoskeleton? Like the electroplated CA shield with flaking issues? Hope not.

Oh god no. It's too damn expensive to have to worry about QC issues like that... let's hope not.

I might put a flex payment in early in case it ships this month.
 
Back
Top