ive had proxima midnight annoying me with her screen accurate but crazy long legs so i cut the ankle peg holder off then the whole leg extender ,superglued with baking powder reinforcement the holder back in place , this removed 1'' from leg length & makes her helas height ( to me it also reduces the tiny hands/pinhead look) trimmed 10mm off trouser length to give shoe more room to angle.
IANS HOT TOYS REPAINTS , MODS & DIORAMAS
- Thread starter IANR
- Start date
Help Support Collector Freaks Forum:
1/6 DIORAMA BATTLE DAMAGED PILLARS FOR NEO MATRIX JOHN WICK HOT TOYS. MEASURES 12 X 12 X 21'' TALL & COULD BE CUT DOWN. SUPER DENSE FOAM LIGHT ENOUGH FOR DETOLF SHELF. REMOVEABLE SUPER DETAILED DAMAGED PILLARS, FLOOR COVERED IN DEBRIS INCLUDING 120 SPENT ROUNDS. YOUR OWN FIGURE STAND CAN BE ADDED AS SHOWN TO ALLOW FLYING/ SOMERSAULT POSES
Attachments
hi got a present toys t-800 deluxe ,very pleased heavy sturdy figure so i took the advice from here & youtube & did the following: 1 cut outwards from every hole to reduce the cookie cutter shapes 2 extended the leg damage hole & painted black inside 3 dry brushed dark grey over all the seams including bandolier & lighter pass over wrinkled areas 4 drilled the bullet hits deeper 5 used 2 shades craft paint for suble blood leaking on the leather & round large wounds 6 used tamiya clear red to gloss up the raw meat 7 light sanding on the grenade launcher then drybrushed all weapons 8 sandy wash on lower half of boots 9 used just a spot of pva to glue in the grenade shells (except 3)as they fell out when posing. 10 hairdryer on the ammo belt so it curves nicely around his feet & done till i build him a diorama probably housing the base. no photos as they would not be good quality.
hi. so i wanted to usb power these 3 figures so i used an r/c plug (ebay 4pk £13) with the 7 port usb hub (ebay £6.30) with 2 usb-c for gantry & mk7 + 1 usb-micro for centurion (total ebay cost £3.50) the background was an internet image (printed for £6)
Attachments
i received the new mk6 & gantry, great product but with unclear instructions. the arms looked unpainted so i car primered grey then silver topcoat, black matt enamel onto the piston housings & 2 shades of wash into recessess. a spot of blu-tac allows exta pieces to be added to the arms.
Attachments
before the mark 7 diecast stand if you wanted to fly a diecast you were taking a risk so years ago i made these to fit on flight stands ( earliest on left) i bent pieces of coathanger then used a 3d printer pen to fill in then sanded smooth, they worked very well.
Attachments
Similar threads
