Thanks! Now I can actually get around to bashing the Stuttgart version while I wait for the new Loki preorder
You're welcome.
Thanks! Now I can actually get around to bashing the Stuttgart version while I wait for the new Loki preorder
Very nice, but the pics could have done without being darkened.
Do you have any pics of it with more light on it?
Also, what suit did you use?
Took the picture late last night with desk lamp.
I'll take more pictures during the day to show more detail when I have time later.
The suit is Toys City Tuxedo set. However, I swap out the shirt and tie to match the move better.
Okay. So it's this one?:
https://www.ebay.co.uk/itm/toy-city...utfits-fit-12-James-bond-figure-/221273689917
Just a normal jacket? Not an overcoat?
Yes, that's the one. It's not an overcoat. I am also looking for a slim overcoat. All the ones I find so far are too bulky.
Very nice, but the pics could have done without being darkened.
Do you have any pics of it with more light on it?
Also, what suit did you use?
I could get this figure locally for $260, which is tempting but I can't bring myself to pull the trigger - I think it's because I'd like to be able to pose him in the more low-key (no pun intended!) outfit that he has on for a lot of Avengers, rather than always in the full regalia with all the gold. Will be interesting to see what the Dark World figure looks like.
Ankles on my Loki (and Avengers Thor) are getting annoyingly weak. I know this is a typical HT problem, but anyone know if the future polish fix works well for it?
I try my best, lol.
Take a strip of black pvc insulating tape(About 100mm long) and lay it down on a cutting mat(In as straight a line as you can). Cut the strip lengthways, and lift one side of it. Remove Loki's boot, leaving the peg on the leg. Wrap the tape tightly around the centre of the peg, making sure to slightly overlap on the base of the peg ***** on either side.
If you do it right, the boot will be a bit of a tight fit, and will have a bit of reinforcement to it now.
Enter your email address to join: