Hot Toys – MMS202D04 - 1/6th scale RoboCop Collectible Figure

[ayoldguy1]

I don’t think anyone’s had any problems with the robocop 3 yet and someone on there said they had revised joints in the torso….
I managed to snag a brand new torso from robocop 3 for mine so Iv got a spare at least

Hey, do you know if the MMS669 Robo 3 torso is compatible with the OG HT Robo legs, arms, head, etc?

Thx

 

[creasy]

Hey, do you know if the MMS669 Robo 3 torso is compatible with the OG HT Robo legs, arms, head, etc?

Thx

I’m not sure about that it’s the same clear plastic joints but the arms fit flusher inside the torso in the original robocop release than they do in the robocop 3.

 

[OzzyAndyHam]

Some new photos of this great figure!

 

[Plex7]

Hey, do you know if the MMS669 Robo 3 torso is compatible with the OG HT Robo legs, arms, head, etc?

Thx

It should be the same mold. I personally purchased the battle damaged helmet for my Robocop 3 figure. Color is slightly off but it fit perfectly. That helmet was a must with the special edition battle damaged chest that came with it.

 

[a-dev]

Some new photos of this great figure!

View attachment 759481
View attachment 759482
View attachment 759483
View attachment 759484
View attachment 759485
View attachment 759486
View attachment 759487

The paint and QC leave a lot to be desired but I still think it's a top tier sculpt, with amazing articulation and display options.

A recommendation though - the mouth on yours isn't seated properly - it should go further down into the chin guard so his mouth won't be so close to his 'nose'. Take off his helmet dome, then detach the chin guard on one side, move the mouth down, then reattach the chin guard around it.

 

[OzzyAndyHam]

The paint and QC leave a lot to be desired but I still think it's a top tier sculpt, with amazing articulation and display options.

A recommendation though - the mouth on yours isn't seated properly - it should go further down into the chin guard so his mouth won't be so close to his 'nose'. Take off his helmet dome, then detach the chin guard on one side, move the mouth down, then reattach the chin guard around it.

Thanks, I'll give it another try. I really tried to set it in as far as it goes, but perhaps needs more force.

 

[choombaz]

Those faceplates can be a pain to get right