dw316
Super Freak
Hi , I am not sure where you live so what I suggest is you measure the hole and then google for a place that sells neodymium magnets close to you then glue a replacement in .
Find a magnet that is the same size or just a bit smaller . The main thing is to get one that is the same thickens and fits in the hole properly .
You might need to get smaller one as far as I know if you get a bigger one and cut it the magnet will lose its magnetism .
I have used this site before but if your not in AUSTRALIA you can just fine a shop that is in your country.
Thanks for that info! I measured it to the best I can and I think it is roughly about 3/16" x 1/8" x 1/32" which I am unable to find in a google search. The closest I could find was this and it is slightly too big by 1/16" on one side, and I'm really not sure how to cut it. Was wondering if anyone had any suggestions about that?
https://www.kjmagnetics.com/proddetail.asp?prod=B3301
They say they might be able to make a custom, I'm wondering if I should try that or if it might be expensive or if my sizes are accurate...
https://www.kjmagnetics.com/custom.asp