Hello there.
General Kenobi-Vader!
Hello there.
It was meant to be!!!Too bad my door is the backdrop. The sun had just come up and that dawn light was perfectly subtle. It was literally gone in about a minute
Or fixing, I had two brush hairs stuck in the paint that I had to remove with pincers on my figure.I feel like the delay is because HT is deliberately screwing up the next batches of this Vader. Too many compliments on it.
I have a tiny air bubble in the black paint on the left diagonal part of the "mouth". It's not really that noticeable....., but it is to me.Or fixing, I had two brush hairs stuck in the paint that I had to remove with pincers on my figure.
That’s the worst kind of noticeableI have a tiny air bubble in the black paint on the left diagonal part of the "mouth". It's not really that noticeable....., but it is to me.
Yeah I have one similar as well. Also there is a rough edge on the helmet. Sucks but not super noticeable.I have a tiny air bubble in the black paint on the left diagonal part of the "mouth". It's not really that noticeable....., but it is to me.
Gotcha, thanks!A first batch went out... seems like a long time ago.
Sept 6th for first batch and nothing since. Thrawn was released ( after Vader) and shipped everywhere already and just released obi notices are going out.. These release batch patterns are getting ridiculous..A first batch went out... seems like a long time ago.
Looking closer at mine, there are also a couple of tiny areas where it appears the gloss coat was rubbed off on the center ridge part on the dome. It looks like light reflections that show under the lights, but you can't see it when the light is off. If you look at the area on the front of the helmet, above the eyebrows, it looks like two light reflections on the edges of the center ridge of the dome. It's the two thin lines on the edge of the ridge; one on either side. The left one is about 1/8" long. The one on the right is about half that long.Yeah I have one similar as well. Also there is a rough edge on the helmet. Sucks but not super noticeable.
Enter your email address to join: